Availability: Usually ships in 24 hours
Amazon.com's Price: $34.45as of 02/22/2018 05:38 EST
- 5.5V tolerant pins. 6V measurement probe
- 1Hz - 40MHz frequency measurement 1kHz - 4MHz pulse-width modulator, frequency generator
- On-board multi-voltage pull-up resistors On-board 3.3volt and 5volt power supplies with software reset
- Bus traffic sniffers (SPI, I2C)
- A bootloader for easy firmware updates
- CPT-063 Test Clip SOIC8 Pomona 5250
- JIUWU Test Hook Clip Ideal for Electronic Experiment
- HiLetgo ESP-WROOM-32 ESP32 ESP-32S Development Board 2.4GHz Dual-Mode WiFi + Bluetooth Dual Cores Microcontroller Processor Integrated with Antenna RF AMP Filter AP STA for Arduino IDE
- Haitronic 120pcs 20cm length Jumper Wires/dupont cable Multicolored(10 color) 40pin M to F, 40pin M to M, 40pin F to F for Breadboard / Arduino based / DIY/ raspberry Pi 2 3/Robot Ribbon Cables Kit
- Micro USB FTDI Basic Breakout Module for Arduino 3.3V/5V
- HESAI Smart Electronics ST LINK Stlink ST-Link V2 Mini STM8 STM32 Emulator Simulator Download Programmer Programming With Cover
- Ubertooth One
- Signstek SOIC8 SOP8 Flash Chip IC Test Clips Socket Adpter Programmer BIOS
- Seeedstudio Open Workbench Logic Sniffer
- Diymall 0.96" Inch Yellow Blue I2c IIC Serial Oled LCD LED Module 12864 128X64 for Arduino Display Raspberry PI 51 Msp420 Stim32 SCR
- see more
The Bus Pirate v3.6a, created by Ian Lesnet, is a troubleshooting tool that communicates between a PC and any embedded device over 1-wire, 2-wire, 3-wire, UART, I2C, SPI, and HD44780 LCD protocols - all at voltages from 0-5.5VDC. This product eliminates a ton of early prototyping effort when working with new or unknown chips.
Working with the Bus Pirate is simple and effective - type commands into a terminal on your computer, those commands are interpreted by the Bus Pirate and sent via the proper protocol. The Pirate will also interpret data sent from your embedded device back to your computer terminal. A big bonus is the bootloader installed on the PIC, which allows you to easily update the firmware and change the functionality of the board.
The main components of the Bus Pirate are the PIC24FJ64 processor and a FT232RL USB-to-Serial chip. A Mini-B USB connector that has also been populated on the board, provides the power to the Bus Pirate and allows you to interact with via your PC. The major difference in this version of the Bus Pirate comes from the shrouded 0.1" pitch 2x5 pin header, which has been flipped around to help standardize this board. Additionally every pin on this header has been labeled, eliminating the need for a separate I/O pin description document like with earlier versions.
2 and 3-wire libraries with bitwise pin control
Scriptable binary bitbang, 1-Wire, I2C, SPI, and UART modes
Note: We include the Bus Pirate Cable
Note: This product is a collaboration with Ian Lesnet. A portion of each sales goes back to them for product support and continued development.
Average Rating: none